Roland SonicCell User Manual

121
Using the SonicCell in Patch Mode
FXM Depth 0–16
Specifies the depth of the modulation produced by FXM.
When the Tempo Sync is set to “ON,” settings related to Pitch (p. 122)
and FXM are disabled.
Wave Coarse Tune
-48–+48
Adjusts the pitch of the waveform’s sound up or down in semitone steps (+/
-4 octaves).
The Coarse Tune of the entire rhythm tone is set by the Tone Coarse Tune
(p. 122).
Wave Fine Tune -50–+50
Adjusts the pitch of the waveform’s sound up or down in 1-cent steps (+/-50
cents).
* One cent is 1/100th of a semitone.
The Fine Tune of the entire rhythm tone is set by the Tone Fine Tune (p.
123).
Wave Level 0–127
You can set the volume of the waveform.
The volume level of each rhythm tone is set with the Tone Level; the volume
levels of the entire rhythm set is set with the Rhythm Level (p. 118).
Wave Pan L64–0–63R
This specifies the pan of the waveform. “L64” is far left, “0” is center, and
“63R” is far right.
Wave Rnd Pan Sw
(Wave Random Pan Switch)
OFF, ON
Use this setting to cause the waveform’s panning to change randomly each
time a key is pressed (ON) or not (OFF).
* The range of the panning change is set by the Random Pan Depth (p.
127).
Alter Pan Sw
(Wave Alternate Pan Switch)
OFF, ON, REVS
This setting causes panning of the waveform to be alternated between left
and right each time a key is pressed. Set Alter Pan Sw to “ON” to pan the
Wave according to the Alter Pan Depth settings, or to “REV” when you want
the panning reversed. If you do not want the panning to change each time
a key is pressed, set this to “OFF.”
Parameter
Value Explanation
SonicCell_e.book 121 ページ ２００７年８月９日 木曜日 午後９時１７分

Roland SonicCell Specifications

General

Brand	Roland
Model	SonicCell
Category	Computer Hardware
Language	English