EasyManua.ls Logo

Roland SonicCell - Page 113

Roland SonicCell
288 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
113
Using the SonicCell in Patch Mode
Key (Keyboard) Range Upper
Lower–G9
Specifies the highest note that the tone will sound for each tone.
If you attempt to raise the lower key higher than the upper key, or to lower
the upper key below the lower key, the other value will be automatically
modified to the same setting.
Key Fade Upper
(Keyboard Fade Width Upper)
0–127
This determines what will happen to the tone’s level when a note that’s high-
er than the tone’s specified keyboard range is played. Higher settings pro-
duce a more gradual change in volume. If you don’t want the tone to sound
at all when a note below the keyboard range is played, set this parameter
to “0.”
Velo Fade Lower
(Velocity Fade Width Lower)
0–127
This determines what will happen to the tone’s level when the tone is played
at a velocity lower than its specified velocity range. Higher settings produce
a more gradual change in volume. If you want notes played outside the
specified key velocity range to not be sounded at all, set this to “0.”
Velo (Velocity) Range Lower
1–UPPER
This sets the lowest velocity at which the tone will sound. Make these settings
when you want different tones to sound in response to notes played at dif-
ferent strengths.
Velo (Velocity) Range upper
LOWER–127
This sets the highest velocity at which the tone will sound. Make these set-
tings when you want different tones to sound in response to notes played at
different strengths.
If you attempt to set the Lower velocity limit above the Upper, or the Upper
below the Lower, the other value will automatically be adjusted to the
same setting.
When using the Matrix Control to have different tones played, set the
lowest value (Lower) and highest value (Upper) of the value of the MIDI
message used.
Velo Fade Upper
(Velocity Fade Width Upper)
0–127
This determines what will happen to the tone’s level when the tone is played
at a velocity greater than its specified velocity range. Higher settings pro-
duce a more gradual change in volume. If you want notes played outside
the specified key velocity range to not be sounded at all, set this to “0.”
Parameter
Value Explanation
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Pitch
Range Lower
Range Upper
Fade Lower
Fade Upper
Level
Velocity
SonicCell_e.book 113 ページ 2007年8月9日 木曜日 午後9時17分

Table of Contents

Other manuals for Roland SonicCell

Related product manuals