Roland SonicCell - Page 45

Recording a Mic or Guitar (USB/Audio Interface)
45
■ USER’S GUIDE
Change the value to “To Input FX.”
For more about the Input “Assign” setting ➝ p. 142
To select the type of input effect
➝ p. 147
To adjust the depth of chorus or reverb
➝ p. 148
fig.disp-InOutRouting.epsfig.disp-InOutRouting-ToCom.eps
Setting the Output to Computer
Press [EFFECT] to access the In/Out Routing screen.
* The illustration at right is an example of the IN/OUT Routing
screen in Performance mode.
Turn [CURSOR/VALUE] to move the cursor to “To Com.”
Press [CURSOR/VALUE].
The To Computer screen will appear.
fig.disp-ToComputer.eps
Turn [CURSOR/VALUE] to move the cursor to the “Type.”
Press [CURSOR/VALUE].
Change the value of Type to “INPUT FX.”
For more about the “Type” setting of To Computer screen
➝ p. 148
fig.disp-EffectSwitch.eps
If the Input Effect is Not Applied
In the In/Out Routing screen, press [MENU] to access the Menu
screen.
Turn the Input Effect “ON.”
If you want to make more detailed effect settings, refer to the following pages.
• Input Effect ➝ p. 147
• Chorus Send Level ➝ p. 148
• Reverb Send Level ➝ p. 148
• Mastering Effect ➝ p. 181
4
5
6
7
8
9
10
MEMO
SonicCell_e.book 45 ページ ２００７年８月９日 木曜日 午後９時１７分