110
Using the SonicCell in Patch Mode
Delay Time
0–127
Delay Time (LFO Delay Time) specifies the time elapsed before the LFO effect
is applied (the effect continues) after the key is pressed (or released).
When using violin, wind, or certain other instrument sounds in a
performance, rather than having vibrato added immediately after the
sounds are played, it can be effective to add the vibrato after the note is
drawn out somewhat. If you set the Delay Time in conjunction with the
Pitch Depth and Rate, the vibrato will be applied automatically following a
certain interval after the key is pressed. This effect is called Delay Vibrato.
After referring to “How to Apply the LFO” (p. 111), change the setting until
the desired effect is achieved.
Delay Time KF (Keyfollow)
-100–100
Adjusts the value for the Delay Time parameter depending on the key posi-
tion, relative to the C4 key (center C). To decrease the time that elapses be-
fore the LFO effect is applied (the effect is continuous) with each higher key
that is pressed in the upper registers, select a positive value; to increase the
elapsed time, select a negative value. Larger settings will produce greater
change. If you do not want the elapsed time before the LFO effect is applied
(the effect is continuous) to change according to the key pressed, set this to
“0.”
Fade Mode
ON <, ON >,
OFF <, OFF >
Specifies how the LFO will be applied.
After referring to “How to Apply the LFO” (p. 111), change the setting until
the desired effect is achieved.
Fade Time
0–127
Specifies the time over which the LFO amplitude will reach the maximum
(minimum).
After referring to “How to Apply the LFO” (p. 111), change the setting until
the desired effect is achieved.
Parameter
Value Explanation
C4C3C2C1 C5 C6 C7
0
+50
+100
-50
-100
Key
Time
SonicCell_e.book 110 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
