119
Using the SonicCell in Patch Mode
Mute Group
OFF, 1–31
On an actual acoustic drum set, an open hi-hat and a closed hi-hat sound
can never occur simultaneously. To reproduce the reality of this situation,
you can set up a Mute Group.
The Mute Group function allows you to designate two or more rhythm tones
that are not allowed to sound simultaneously. Up to 31 Mute Groups can be
used. rhythm tones that are not belong to any such group should be set to
“OFF.”
Env Mode
(Rhythm Tone Envelope Mode)
NO-SUS,
SUSTAIN
When a loop waveform (p. 97) is selected, the sound will normally continue
as long as the key is pressed. If you want the sound to decay naturally even
if the key remains pressed, set this to “NO-SUS.”
If the One Shot Mode (p. 97) is ON, it will not sustain even if this
parameter is set to “SUSTAIN.”
Pitch Bend Range
(Rhythm Tone Pitch Bend
Range)
0–48
Specifies the amount of pitch change in semitones (4 octaves) that will occur
when the Pitch Bend Lever is moved. The amount of change when the lever
is tilted is set to the same value for both left and right sides.
Rx Expression
(Rhythm Tone Receive Expres-
sion Switch)
OFF, ON
For each rhythm tone, specify whether MIDI Expression messages will be re-
ceived (ON), or not (OFF).
Rx Hold-1
(Rhythm Tone Receive Hold-1
Switch)
OFF, ON
For each rhythm tone, specify whether MIDI Hold-1 messages will be re-
ceived (ON), or not (OFF).
If “NO-SUS” is selected for Env Mode, this setting will have no effect.
Rx Pan
(Rhythm Tone Receive Pan
Mode)
CONTINUOUS,
KEY-ON
For each rhythm tone, specify how pan messages will be received.
CONTINUOUS:
Whenever Pan messages are received, the stereo
position of the tone will be changed.
KEY-ON:
The pan of the tone will be changed only when the next
note is played. If a pan message is received while a
note is sounding, the panning will not change until the
next key is pressed.
The channels cannot be set so as not to receive Pan messages.
One Shot Mode
OFF, ON
The sound will play back until the end of the waveform (or the end of the
envelope, whichever comes first). The result will be the same as when the
envelope’s Tone Env Mode is set to NO-SUS.
Relative Level
-64–+63
Corrects for the volume of the rhythm tone.
This parameter is set by the key-based controller system exclusive message.
Normally, you should leave it set to 0.
If the rhythm tone level is set to 127, the volume will not increase beyond
that point.
Rhythm Tone Name
12 characters
You can assign a name of up to twelve characters to the currently selected
rhythm tone.
1.
Move the cursor to the location at which you want to enter a character,
then press [CURSOR/VALUE].
2.
Turn [CURSOR/VALUE] to select the character you want to enter, then
press [CURSOR/VALUE].
Parameter Value Explanation
SonicCell_e.book 119 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
