200
Effects List
The Rotary effect simulates the sound of the rotary speakers
often used with the electric organs of the past. Since the
movement of the high range and low range rotors can be set
independently, the unique type of modulation characteristic of
these speakers can be simulated quite closely. This effect is
most suitable for electric organ Patches.
fig.MFX-21
This type provides modified response for the rotary speaker,
with the low end boosted further.
This effect features the same specifications as the VK-7’s built-
in rotary speaker.
fig.MFX-22
This is a stereo chorus. A filter is provided so that you can
adjust the timbre of the chorus sound.
fig.MFX-23
21:
ROTARY
Parameter
Value Description
Speed #
SLOW, FAST
Simultaneously switch the rotational
speed of the low frequency rotor
and high frequency rotor.
SLOW:
Slows down the rotation
to the Slow Rate.
FAST:
Speeds up the rotation to
the Fast Rate.
Wf Slow Speed
0.05–10.00 Hz
Slow speed (SLOW) of the low fre-
quency rotor
Wf Fast Speed
0.05–10.00 Hz
Fast speed (FAST) of the low fre-
quency rotor
Wf Acceleration
0–15
Adjusts the time it takes the low fre-
quency rotor to reach the newly se-
lected speed when switching from
fast to slow (or slow to fast) speed.
Lower values will require longer
times.
Wf Level
0–127
Volume of the low frequency rotor
Tw Slow Speed
0.05–10.00 Hz
Settings of the high frequency rotor
The parameters are the same as
for the low frequency rotor
Tw Fast Speed
0.05–10.00 Hz
Tw Acceleration
0–15
Tw Level
0–127
Separation
0–127
Spatial dispersion of the sound
Level #
0–127
Output Level
22:
VK ROTARY
Parameter
Value Description
Speed #
SLOW, FAST
Rotational speed of the rotating
speaker
Brake #
OFF, ON
Switches the rotation of the rota-
ry speaker.
When this is turned on, the ro-
tation will gradually stop.
When it is turned off, the rota-
tion will gradually resume.
Wf Slow Speed
0.05–10.00 Hz
Low-speed rotation speed of the
woofer
Wf Fast Speed
0.05–10.00 Hz
High-speed rotation speed of the
woofer
Rotary
L out
R out
L in
R in
L out
R out
L in
R in
Rotary
2-Band EQ
2-Band EQ
Wf Trans Up
0–127
Adjusts the rate at which the
woofer rotation speeds up when
the rotation is switched from
Slow to Fast.
Wf Trans Down
0–127
Adjusts the rate at which the
woofer rotation speeds up when
the rotation is switched from Fast
to Slow.
Wf Level
0–127
Volume of the woofer
Tw Slow Speed
0.05–10.00 Hz
Settings of the tweeter
The parameters are the same
as for the woofer.
Tw Fast Speed
0.05–10.00 Hz
Tw Trans Up
0–127
Tw Trans Down
0–127
Tw Level
0–127
Spread
0–10
Sets the rotary speaker stereo im-
age. The higher the value set, the
wider the sound is spread out.
Low Gain
-15– +15 dB
Gain of the low range
High Gain
-15– +15 dB
Gain of the high range
Level #
0–127
Output Level
23:
CHORUS
Parameter
Value Description
Filter Type
OFF, LPF, HPF
Type of filter
OFF:
no filter is used
LPF:
cuts the frequency range
above the Cutoff Freq
HPF:
cuts the frequency range
below the Cutoff Freq
Cutoff Freq
200–8000 Hz
Basic frequency of the filter
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the di-
rect sound until the chorus sound
is heard.
Rate #
0.05–10.00 Hz, note
Frequency of modulation
Depth
0–127
Depth of modulation
Phase
0–180 deg
Spatial spread of the sound
Low Gain
-15– +15 dB
Gain of the low range
High Gain
-15– +15 dB
Gain of the high range
Balance #
D100:0W–D0:100W
Volume balance between the direct
sound (D) and the chorus sound (W)
Level
0–127
Output Level
Parameter
Value Description
L in
R in
Chorus
Chorus
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
SonicCell_e.book 200 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
