202
Effects List
This is a chorus effect with added Tremolo (cyclic modulation
of volume).
fig.MFX-27
This is a multiple chorus that applies two-phase modulation in
stereo. It gives no impression of modulation, but produces a
transparent chorus effect.
fig.MFX-28
This applies a 3D effect to the chorus sound. The chorus sound
will be positioned 90 degrees left and 90 degrees right.
fig.MFX-29
27:
TREMOLO CHORUS
Parameter
Value Description
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the di-
rect sound until the chorus sound
is heard.
Chorus Rate #
0.05–10.00 Hz, note
Modulation frequency of the cho-
rus effect
Chorus Depth
0–127
Modulation depth of the chorus ef-
fect
Tremolo Rate #
0.05–10.00 Hz, note
Modulation frequency of the trem-
olo effect
Tremolo
Separation
0–127
Spread of the tremolo effect
Tremolo Phase
0–180 deg
Spread of the tremolo effect
Balance #
D100:0W–D0:100W
Volume balance between the di-
rect sound (D) and the tremolo
chorus sound (W)
Level
0–127
Output Level
28:
SPACE-D
Parameter
Value Description
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the
direct sound until the chorus
sound is heard.
Rate #
0.05–10.00 Hz, note
Frequency of modulation
Depth
0–127
Depth of modulation
Phase
0–180 deg
Spatial spread of the sound
Low Gain
-15– +15 dB
Gain of the low range
High Gain
-15– +15 dB
Gain of the high range
Balance #
D100:0W–D0:100W
Volume balance between the
direct sound (D) and the chorus
sound (W)
Level
0–127
Output Level
Tremolo Chorus
L in
R in
L out
R out
Balance D
Balance D
Balance W
Balance W
L in
R in
Space D
Space D
L out
R out
2-Band
EQ
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
29:
3D CHORUS
Parameter
Value Description
Filter Type
OFF, LPF, HPF
Type of filter
OFF:
no filter is used
LPF:
cuts the frequency range
above the Cutoff Freq
HPF:
cuts the frequency range
below the Cutoff Freq
Cutoff Freq
200–8000 Hz
Basic frequency of the filter
Pre Delay
0.0–100.0 ms
Adjusts the delay time from the di-
rect sound until the chorus sound is
heard.
Rate #
0.05–10.00 Hz, note
Frequency of modulation
Depth
0–127
Modulation depth of the chorus ef-
fect
Phase
0–180 deg
Spatial spread of the sound
Output Mode
SPEAKER, PHONES
Adjusts the method that will be
used to hear the sound that is out-
put to the OUTPUT jacks. The opti-
mal 3D effect will be achieved if
you select
SPEAKER
when using
speakers, or
PHONES
when using
headphones.
Low Gain
-15– +15 dB
Gain of the low range
High Gain
-15– +15 dB
Gain of the high range
Balance #
D100:0W–D0:100W
Volume balance between the di-
rect sound (D) and the chorus
sound (W)
Level
0–127
Output Level
L
R
3D Chorus
2-Band
EQ
2-Band
EQ
R out
L out
SonicCell_e.book 202 ページ 2007年8月9日 木曜日 午後9時17分