92
Using the SonicCell in Patch Mode
Porta Sw
(Portamento
Switch)
OFF, ON
Specifies whether the portamento effect will be applied (ON) or not (OFF).
*
Portamento
is an effect which smoothly changes the pitch from the first-played key to the
next-played key. By applying portamento when the Mono/Poly is “MONO,” you can sim-
ulate slide performance techniques on a violin or similar instrument.
Porta Mode
(Portamento
Mode)
NORMAL,
LEGATO
Specifies the performance conditions for which portamento will be applied.
NORMAL:
Portamento will always be applied.
LEGATO:
Portamento will be applied only when you play legato (i.e., when you press
the next key before releasing the previous key).
Porta Type
(Portamento
Type)
RATE, TIME
Specifies the type of portamento effect.
RATE:
The time it takes will depend on the distance between the two pitches.
TIME:
The time it takes will be constant, regardless of how far apart in pitch the notes are.
Porta Start
(Portamento
Type)
PITCH, NOTE
When another key is pressed during a pitch change produced by portamento, a new pitch
change will begin. This setting specifies the pitch at which the change will begin.
Porta Time
(Portamento
Time)
0–127
When portamento is used, this specifies the time over which the pitch will change. Higher
settings will cause the pitch change to the next note to take more time.
Part Mod Sw
(Part Modulation
Depth Switch)
OFF, ON
Specifies whether the part’s modulation depth range setting (the value specified by RPN) will
be enabled (ON) or disabled (OFF).
Parameter
Value Explanation
C5
D4
C4
press D4 key
Pitch
Time
press C4 key
press C5 key
C5
D4
C4
press D4 key
Pitch
Time
press C4 key
press C5 key
PITCH:
Starts a new portamento when another key is pressed while the pitch
is changing.
NOTE:
Portamento will begin anew from the pitch where the current change
would end.
SonicCell_e.book 92 ページ ２００７年８月９日 木曜日 午後９時１７分
To Next Page
Loading...
Need help?
General
