SCM CU 300C - Safety guards

INDEX
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9A.33.2 Adjust spindle moulder hood for moulding with removal. .................. 22
9A.33.3 Use of hood-fence for small pieces ....................................................... 24
9A.33.4 Hood-fence adjusting for profiling with rotation direction reversal ... 25
9A.33.5 Working examples................................................................................... 28
9A.38.4 Hood-fence unit adjusting for working at the front end...................... 32
9A.44 Tenoning hood............................................................................................ 34
9A.44.1 Adjusting .................................................................................................. 34
9A.50 Pressure unit for profiling ......................................................................... 36
9A.50.1 Adjusting .................................................................................................. 38
9A.55 Guard for milling at the spindle ................................................................ 40
9A.55.2 Adjusting .................................................................................................. 41
9A.55.3 Working examples................................................................................... 44
9A.55.4 Maintenance............................................................................................. 45
10 USE AND ADJUSTMENT OF PLANER SPINDLE GUARD AND SAFE WORKING1
10.1 Cutterblock guard ........................................................................................... 2
10.1.1 Description ................................................................................................... 2
10.1.2 Guard adjusting............................................................................................ 2
10.3 Procedures for safe working.......................................................................... 4
10.3.1 Examples ...................................................................................................... 4
10.3.1.1 Surfacing workpieces of thickness less 75 mm..................................... 6
10.3.1.2 Straightening ............................................................................................. 8
10.3.1.3 Surfacing and straightening pieces thicker than 75 mm .................... 10
10.3.1.4 Surfacing pieces of square section....................................................... 12
10.3.1.5 Surfacing short pieces ........................................................................... 13
10.3.1.6 Straightening short pieces..................................................................... 14
10.3.1.7 Chamfering along the fence................................................................... 15
10.3.1.8 Surfacing workpieces with small section ............................................. 16
10.3.1.9 Straightening workpieces of small section .......................................... 17
10.3.1.10 Machining of narrow work-pieces ....................................................... 18
10.5 Safety notes................................................................................................... 20
15 PUSHER .................................................................................................................... 1
15.1 Pusher .............................................................................................................. 2
20 MAINTENANCE......................................................................................................... 1