SCM CU 300C - Pressure rollers adjusting

INDEX
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
8.3.1 Slot depth limitation....................................................................................... 9
8.3.2 Slot width limitation ..................................................................................... 10
8.3.3 Height adjusting ........................................................................................... 11
9 THICKNESSING USE AND ADJUSTING ................................................................. 1
9.1 Preliminary adjustment for passing from planing to thicknessing.............. 2
9.1.1 Machine with manual table lifting................................................................. 2
9.2 Adjustment to pass from thicknessing to surface planing........................... 4
9.2.1 Machine with manual table lifting................................................................. 4
9.4 Automatic feed and speed change.................................................................. 6
9.5 Manual adjusting of thicknessing table .......................................................... 7
9.5.1 Adjusting standard indicator ........................................................................ 8
9.8 Pressure rollers adjusting................................................................................ 9
9.9 Safety guards .................................................................................................. 10
9.10 Knife adjustment ........................................................................................... 12
9.11 Knife replacing .............................................................................................. 12
9.12A Helicoidal planer - Tips replacement ........................................................ 12
9.12 Replacing the throw-away knives................................................................ 12
9a OPERATIONS AND ADJUSTMENTS OF SPINDLE ................................................ 1
9A.1 Adjustments.................................................................................................... 4
9A.1.1 Spindle height adjusting............................................................................. 4
9A.1.1.1 Spindle height adjusting.......................................................................... 4
9A.3 Spindle speed selection................................................................................. 6
9A.3.1 Speed change .............................................................................................. 7
9A.3.1.1 Speed change ........................................................................................... 8
9A.6 Telescopic rule on tenoning table .............................................................. 10
9A.6.1 Rule rotation .............................................................................................. 10
9A.6.2 To move the rule up to the tool ................................................................ 10
9A.8 Using the tenoning table.............................................................................. 12
9A.8.1 Tenoning .................................................................................................... 14
9A.8.1.1 Clamping arm use .................................................................................. 14
9A.8.2 Oblique tenons .......................................................................................... 16
9A.8.2.1 Clamping arm use .................................................................................. 16
9A.33 Adjustable Hood-Fence unit...................................................................... 18
9A.33.1 Adjust spindle moulder hood guide for moulding without removal... 21