INDEX
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
7.4 Use of telescopic ruler...................................................................................... 3
7.14 Manual fence for parallel cuts........................................................................ 4
7.14.1 Setting to zero the fence for parallel cuts.................................................. 4
7.14.2 Operation ...................................................................................................... 6
7.23 Use of sliding table and frame for large panels ......................................... 12
7.23.1 Aluminium sliding table............................................................................. 12
7.23.6 Use of the presser unit .............................................................................. 14
7.24 Example: longitudinal cut ............................................................................ 16
7.24.1 First cut ....................................................................................................... 16
7.24.2 Second cut (squaring) ............................................................................... 18
7.24.3 Third cut...................................................................................................... 18
7.24.4 Fourth cut ................................................................................................... 19
7.24.5 Cut for obtaining pieces with opposite sides parallel ............................ 21
7.24.6 Rule adjusting for oblique cuts ............................................................... 24
7.24.6.1 Example for positioning the rule for oblique cuts ............................... 25
7.25 Additional rule for oblique cuts with millimeter rule ................................. 26
7a SURFACER USE AND ADJUSTING ....................................................................... 1
7A.1 Knife adjustment ............................................................................................ 2
7A.2 Knife replacing................................................................................................ 5
7A.4 Replacing the throw-away knives ................................................................. 6
7A.5 Helicoidal planer - Tips replacement ............................................................ 8
7A.6 Surfacing tables adjusting........................................................................... 10
7A.6.1 Inlet table.................................................................................................... 10
7A.6.2 Outlet table................................................................................................. 11
7A.8 Fence ............................................................................................................. 12
7A.8.1 Longitudinal shifting ................................................................................. 12
7A.8.2 Tilting.......................................................................................................... 12
7A.9 Fence ............................................................................................................. 14
8 USE AND ADJUSTMENT OF MORTISER................................................................ 1
8.1 Fitting the parts demounted for transport reasons ....................................... 2
8.1.1 Mortiser fitting ................................................................................................ 2
8.1.2 Spindle bits - assembly ................................................................................. 4
8.2 Mortiser use....................................................................................................... 6
8.3 Adjustments ...................................................................................................... 8
To Next Page
Loading...
