SCM CU 300C - Manual adjusting of thicknessing table

INDEX
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.76.1 Interchangeable spindle ......................................................................... 40
4.3.82 Tool fitting - SAFETY NOTES.................................................................... 43
4.3.82.1 Tool fitting................................................................................................ 44
4.4 Electric connection and grounding............................................................... 47
4.4.1 Requisites for the electricity supply system ............................................. 47
4.4.2 Electric connection ...................................................................................... 50
4.4.3 Check the correct connection..................................................................... 50
4.5 Connection to the suction system ................................................................ 52
5 CONTROLS ............................................................................................................... 1
5.1 Controls board .................................................................................................. 2
5.2 Emergency buttons........................................................................................... 3
5.4 General controls before machine starting...................................................... 4
5.4.1 Profiling operations ....................................................................................... 6
5.4.2 Milling at the spindle (shaping) .................................................................... 6
5.4.3 Tenoning ......................................................................................................... 6
5.5 Machine start-up - shutdown ........................................................................... 9
5.5.1 Machine with COUNTERCLOCKWISE SPINDLE ROTATION (against feed
direction)................................................................................................................. 12
5.5.2 Machine with CLOCKWISE rotation (feed direction) ................................ 12
5.11 Auto-brake motor .......................................................................................... 14
6 SAW UNIT USE AND ADJUSTMENT....................................................................... 1
6.1 Riving knife adjusting....................................................................................... 2
6.3 Axis positioning ................................................................................................ 4
6.3.1 Height adjusting of the saw unit................................................................... 4
6.3.2 Saw blade tilting............................................................................................. 4
6.3.4 Scorer adjusting............................................................................................. 6
6.3.4.1 Scorer height adjusting .............................................................................. 6
6.3.4.2 Aligning the scorer with the saw blade..................................................... 6
6.4 Correct use for circular saw............................................................................. 7
6.7 Grooves with saw blade ................................................................................... 8
6.8 Guard adjusting............................................................................................... 11
7 SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT........................................................................................................... 1
7.1.3 Splinter guard adjustment............................................................................. 2