EN
4 - INSTALLATION
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 4 Pag. 1/53
INDEX
4.1 Unloading the machine ..............................................................................4
4.2 Machine positioning ...................................................................................6
4.3 Fitting the parts demounted for transport reasons .....................................8
4.3.A Displacing wheels - Assembly....................................................................8
SAW / SAW - SPINDLE MOULDER ........................................................10
4.3.1.1 Table support device assembly on the sliding table.................................10
4.3.11 Table for sliding table - installation...........................................................11
4.3.12 Fitting the guard for saw blade and scorer...............................................12
4.3.14 Fitting the additional tables ......................................................................14
4.3.14.2 Fitting the additional table at exit side ......................................................14
4.3.24 Fitting the supporting frame .....................................................................16
4.3.24.2 Fitting the rest rule ...................................................................................17
4.3.30.1 Fitting the angled cuts device...................................................................18
4.3.31 Wagon attachment - Installation...............................................................19
4.3.32 Plane and saw fence - Installation ...........................................................20
4.3.33.1 Saw guide assembly with micrometric adjustment...................................21
4.3.36 Fitting scorer assembly ............................................................................22
4.3.40 Riving knife fitting .....................................................................................24
4.3.41 Fitting the saw blade ................................................................................24
4.3.43 Fitting - DADO SET..................................................................................27
4.3.45 Fitting the scorer ......................................................................................30
SURFACE PLANING AND THICKNESSING MACHINE .........................32
To Next Page
Loading...
