Siemens SIMATIC S7-300 Module data Reference Manual

Parameter Sets for Signal Modules
A-37
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Data record 1 structure
The figure below shows the structure of data record 1 for the parameters of the
analog output modules.
You activate the diagnostics interrupt enable by setting the corresponding bit in
byte 0 to “1”.
Byte 0
76 0
Byte 1
Channel group 0
Channel group 1
Channel group 3
Channel group 2
Behavior on CPU STOP
Byte 2
Byte 3
Byte 4
Byte 5
7043
Output channel group 0
Output channel group 2
Output channel group 1
Output channel group 3
Output Range
Output type
Substitute value channel
group 0
Substitute value channel
group 1
Substitute value channel
group 2
Substitute value channel
group 3
Low-Order Byte
Low-Order Byte
Low-Order Byte
Low-Order Byte
High-Order Byte
High-Order Byte
High-Order Byte
High-Order Byte
Byte 6
Byte 7
Byte 8
Byte 9
Byte 10
Byte 11
Byte 12
Byte 13
70321
Diagnostics interrupt enable
Refer to Table A-29
0 = Outputs
de-energized
1 = Hold last value
Figure A-17 Data Record 1 for Parameters of the Analog Output Modules

Siemens SIMATIC S7-300 Module data Specifications

General

Series	S7-300
Manufacturer	Siemens
Protection Class	IP20
System	SIMATIC S7-300
Digital Inputs	Varies by module
Digital Outputs	Varies by module
Analog Inputs	Varies by module
Analog Outputs	Varies by module
Central Processing Unit	Varies by CPU model
Supply Voltage	24V DC or 120/230V AC
CPU Type	Varies (e.g., CPU 312, CPU 315, etc.)
Memory	Varies by CPU model
Communication Interfaces	MPI, PROFIBUS
Programming Languages	LAD, FBD, STL, SCL, GRAPH
Operating Temperature	0°C to 60°C
Storage Temperature	-40°C to 70°C
Relative Humidity	10% to 95% (non-condensing)