EasyManuals Logo

Siemens SIMATIC S7-300 Module data Reference Manual

Siemens SIMATIC S7-300 Module data
574 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
Digital Modules
3-10
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
3.2 Sequence of Steps from Choosing to Commissioning the
Digital Module
Introduction
The following table contains the tasks that you have to perform one after the other
to commission digital modules successfully.
The sequence of steps is a suggestion, but you can perform individual steps either
earlier or later (for example, assign parameters to the module) or install other
modules or install, commission etc. other modules in between times.
Sequence of steps
Table 3-7 Sequence of Steps from Choosing to Commissioning the Digital Module
Step Procedure Refer To...
1. Select the module Section 3.1 and specific module section from
Section 3.5
2. Install the module in the
SIMATIC S7 network
“Mounting” section in the Installation Manual for
the programmable logic controller being used:
S7-300 Programmable Controllers, Hardware
and Installation or S7-400, M7-400
Programmable Controllers, Hardware and
Installation
or
ET 200M Distributed I/O Device
3. Assign parameters to module Section 3.3
4. Commission configuration “Commissioning” section in the Installation
Manual for the programmable controller being
used:
S7-300 Programmable Controllers, Hardware
and Installation or S7-400, M7-400
Programmable Controllers, Hardware and
Installation
or
ET 200M Distributed I/O Device
5. If commissioning was not
successful, diagnose
configuration
Section 3.4

Table of Contents

Other manuals for Siemens SIMATIC S7-300 Module data

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC S7-300 Module data and is the answer not in the manual?

Siemens SIMATIC S7-300 Module data Specifications

General IconGeneral
SeriesS7-300
ManufacturerSiemens
Protection ClassIP20
SystemSIMATIC S7-300
Digital InputsVaries by module
Digital OutputsVaries by module
Analog InputsVaries by module
Analog OutputsVaries by module
Central Processing UnitVaries by CPU model
Supply Voltage24V DC or 120/230V AC
CPU TypeVaries (e.g., CPU 312, CPU 315, etc.)
MemoryVaries by CPU model
Communication InterfacesMPI, PROFIBUS
Programming LanguagesLAD, FBD, STL, SCL, GRAPH
Operating Temperature0°C to 60°C
Storage Temperature-40°C to 70°C
Relative Humidity10% to 95% (non-condensing)

Related product manuals