EasyManuals Logo

Siemens SIMATIC S7-300 Module data Reference Manual

Siemens SIMATIC S7-300 Module data
574 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #554 background imageLoading...
Page #554 background image
Glossary
Glossary-6
Programmable Logic Controllers S7-300 Module Data
A5E00105505-03
Measuring range module
Measuring range modules are plugged into the analog input modules for adapta-
tion to different measuring ranges.
Module filtering mode
By operating mode we mean:
1. The selection of an operating mode of the CPU using the mode switch or the
PG
2. The type of program execution in the CPU
3. A parameter in STEP 7 for analog input modules
Monoflop time
Parameter in STEP 7 for position detection module SM 338; POS-INPUT. The
monoflop time is the time interval between 2 SSI message frames ( Encoder
absolute).
MPI
The multipoint interface (MPI) is the programmer port of the SIMATIC S7. It is
used to access programmable modules ((CPUs, CPs), text displays and operator
panel from a central point. The nodes on the MPI can communicate with each
other.
Non-isolated
In the case of non-isolated input/output modules, the reference potentials of the
control and load circuit are electrically connected.
Normalizing
Parameter in STEP 7 for position detection module SM 338; POS-INPUT.
Normalizing right justifies the encoder value of the encoder absolute; non-rel-
evant places are discarded.
OB
Organization block
Operational limit
The operational limit is the measuring or output error of the analog module over
the entire temperature range, referred to the rated range of the analog module.

Table of Contents

Other manuals for Siemens SIMATIC S7-300 Module data

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC S7-300 Module data and is the answer not in the manual?

Siemens SIMATIC S7-300 Module data Specifications

General IconGeneral
SeriesS7-300
ManufacturerSiemens
Protection ClassIP20
SystemSIMATIC S7-300
Digital InputsVaries by module
Digital OutputsVaries by module
Analog InputsVaries by module
Analog OutputsVaries by module
Central Processing UnitVaries by CPU model
Supply Voltage24V DC or 120/230V AC
CPU TypeVaries (e.g., CPU 312, CPU 315, etc.)
MemoryVaries by CPU model
Communication InterfacesMPI, PROFIBUS
Programming LanguagesLAD, FBD, STL, SCL, GRAPH
Operating Temperature0°C to 60°C
Storage Temperature-40°C to 70°C
Relative Humidity10% to 95% (non-condensing)

Related product manuals