Simrad EK80 - Installing One or more Transducers

162
394149/C
bOntherighthandsideofthemenu,clickControlPanel.
cSelectNetworkandSharingCenter.
(IftheControlPanelisshownwithcategories,selectViewnetworkstatusand
tasks.)
dOnthelefthandmenu,selectChangeadaptersettings.
eClickonceonyournetworkadaptertoselectit,thenright-clickandselect
Propertiesontheshort-cutmenu.
fOnthelistofconnections,clickInternetProtocol4(TCP/IPv4),andthenProperties.
3SelectUsethefollowingIPaddress,andtypetheIPaddressandnetworkmask.
IPAddress:157.237.15.16(Example,anyIPaddresscanbeused)
Subnetmask:255.255.255.0
YoucanleaveSubnetmaskblankandclickOK.Whenyouseeanerrormessage
sayingthatthemessagesubnetmaskismissing,clickOKagain.Asubnetmaskwill
thenautomaticallybegenerated.
4ClickOKtosavethesettings,thencloseallthedialogboxes.
Installingoneormoretransducers
ThetransducersyouwishtousewithyourEK80Widebandscienticechosoundermustbe
"installed"asapartofthesoftwareconguration.Whichtransducerstousedependsonthe
numberoftransceiversinyoursystem,andthelicensesyouhaveforthese.
Prerequisites
ItisassumedthattheEK80softwarehasbeeninstalled,andthatallrelevantlicensestrings
havebeenapplied.
Context
TransducersareinstalledusingtheTransducerpageintheInstallationdialogbox.
ThelistoftransducersisgeneratedfromasystemleonyourProcessorUnit.Itcontainsall
transducerscompatiblewiththeWideBandTransceiver(WBT)aswellaskeytechnical
informationabouteachtransducer.
Procedure
1ClicktheSetupicon.
TheiconislocatedundertheMainmenu.ItisusedtoopentheSetupmenu.
SimradEK80