Sirona Intego - Page 307

64 57 498 D3543
D3543.201.01.05.02 08.2016
307
Sirona Dental Systems GmbH 10Overview of all function keys
Operating Instructions INTEGO 10.3Start dialog for removed instruments
båÖäáëÜ
Setting the automatic motor stop of the ApexLocator
When the
Apex Stop key is pressed, the – and + keys are displayed. The
automatic motor stop can be switched off or set to four different levels. If
the distance is 0, the motor does not stop until it reaches the physiological
apex. Please note that the distance values are not a metric length
measurement!
The preset motor stop position is displayed as a black triangle to the right
of the distance display under the text "Stop".
AutoReverse
Switching the ApexLocator Auto-Reverse function on or off. When the
physiological apex is reached, the burr drive automatically switches to
counterclockwise rotation when reactivated by the foot control. When the
file is withdrawn, the bur drive automatically switches back to clockwise
rotation.
Apex acoustic signals
Switching the apex signal tones on and off. If the signal tones are
switched on, a beep is issued when the apex or a set motor stop position
is reached. If the signal tones are switched on, a beep is issued when the
apex or a set motor stop position is reached. If the AutoReverse function
is activated, three acoustic signals are issued when the motor switches to
counterclockwise rotation.
Apex distance acoustic signals
Switching the apex distance signal tones on or off. The intervals between
the signal tones vary according to the measured distance to the apex.
Direct starter/control foot switch (only with the C
+
electronic foot control)
Direct starter (highlighted gray): Switches the motor or SIROSONIC L
scaler on with the set speed or intensity
Control foot switch (highlighted orange): Regulates the motor or
SIROSONIC L scaler to the set speed or intensity after setting the foot
switch pedal to maximum.
Apex
Stop
0.5
Apex
Auto
Rev
Apex Dist