Static IPv4 Address: This is the unique address assigned by the net
work administrator. The default static IP address of the NetClock unit
is 10.10.201.1. In the format “#.#.#.#” with no leading zeroes
or spaces, where each ‘#’ is a decimal integer from the range
[0,255].
Table 2-5:
Default IP addresses
ETH port
Default "static lease"
IP address
ETH0 10.10.201.1
ETH1 10.10.201.2
ETH2 10.10.201.3
ETH3 10.10.201.4
The default subnet is: 255.255.0.0
Netmask: This is the network subnet mask assigned by the network
administrator. In the form “xxx.xxx.xxx.xxx.” See "Subnet
Mask Values" on page53 for a list of subnet mask values.
IPv4 Gateway: The gateway (default router) address is needed if
communication to the NetClock is made outside of the local net
work. By default, the gateway is disabled.
DNS Primary: This is the primary DNS address to be used for this
port.
Depending on how your DHCP server is configured, this is set auto
matically once DHCP is enabled. Alternatively, you may configure
your DHCP server to NOT use a DNS address. When DHCP is dis
abled, DNS Primary is set manually, using the format "#.#.#.#"
2.14 Configuring Network Settings
CHAPTER 2 • NetClock User Reference Guide Rev. 16
61
To Next Page
Loading...
