Spectracom NetClock 9489 - Page 8

2.15.1 Checklist NTP Configuration
96
2.15.2 The NTP Setup Screen
96
2.15.3 Dis-/Enabling NTP
99
2.15.4 Viewing NTP Clients
100
2.15.5 Restoring the Default NTP Configuration
100
2.15.6 NTP Output Timescale
101
2.15.7 NTP Reference Configuration
103
2.15.7.1 The NTP Stratum Model
103
2.15.7.2 Configuring "NTP Stratum 1" Operation
103
2.15.7.3 Configuring "NTP Stratum Synchronization"
104
2.15.8 NTP Servers and Peers
105
2.15.8.1 The NTP Servers and NTP Peers Panels
107
2.15.8.2 NTP Servers: Adding, Configuring, Removing
108
2.15.8.3 NTP Peers: Adding, Configuring, Removing
110
2.15.9 NTP Authentication
112
2.15.9.1 NTP Autokey
112
2.15.9.2 NTP: Symmetric Keys (MD5)
118
2.15.10 NTP Access Restrictions
120
2.15.11 Enabling/Disabling NTP Broadcasting
122
2.15.12 NTP over Anycast
123
2.15.12.1 Configuring NTP over Anycast (General Settings)
124
2.15.12.2 Configuring NTP over Anycast (OSPF IPv4)
125
2.15.12.3 Configuring NTP over Anycast (OSPF IPv6)
126
2.15.12.4 Configuring NTP over Anycast (BGP)
127
2.15.12.5 Configuring Anycast via NTP Expert Mode
128
2.15.12.6 Testing NTP over Anycast
131
2.15.13 NTP Orphan Mode
131
2.15.14 Host Disciplining
132
2.15.14.1 Enabling Host Disciplining
132
2.15.15 NTP Expert Mode
133
2.15.16 Spectracom Technical Support for NTP
136
2.16 Configuring Input References
137
2.17 Configuring Outputs
137
2.17.1 The Outputs Screen
138
2.17.2 The 1PPS and 10MHz Outputs
139
2.17.2.1 Configuring a 1PPS Output
140
2.17.2.2 Configuring the 10 MHz Output (NetClock 9483 Only)
141
VI
NetClock User Reference Guide • TABLE OF CONTENTS