Studer Vista 1 - Page 293

To Next Page

To Previous Page

Vista 1 Digital Mixing System

GC Operation 4-117

Document generated: 18.04.17

SW V5.3

4. The Triggers have to be set according to the application of the selected relay.

All Triggers always work in a logical AND fashion:

  • ThedesiredSourcemustbepatchedtotheappropriateChannel(implicitly

understood and done in the Patch), and

There is the possibility to check up to five other Triggers to finally trigger the

relay:

  • Userkey1,and

  • Userkey2,and

  • InputSelector,and

  • ChannelOn(MUTE),and

  • Faderopen.

Any combination of the five possibilities above can be used. It is also possible

to select from a default list of pre-configured Trigger combinations:

  • Faderstart,or

  • UserDefined.

Typical fader start setup for two stereo sources (I77/I78 and I79/I80):

Fader Start

rigger Defaults

The typical Fader Start Trigger combination is:

  • Inputselector,and

  • Channelon(MUTE),and

  • Fader(open).

Other manuals for Studer Vista 1