2.1+EDR Module (Enhanced Data Rates)
This instrument supports wireless connection via Fully Qualified Bluetooth system v2.1 + EDR Module, CE
and FCC. This connectivity is compatible with mobile and PC devices that support Bluetooth
®
2.1.
The instrument contains a wireless transmission module, WT12 from Bluegiga technologies. Copies of the
modules regional approvals certificates may be obtained from Svantek or Bluegiga.
• Bluetooth version: 2.0
• Operating frequency range: 2.402 – 2.480 GHz
• Transmit power (max): 3 dBm
• Sensitivity: -86 dBm
• Channels: 40
• Modulation: GFSK
• Internal antenna gain: 0.5 dBi
• Range: typically >30m line-of-sight and depending on local RF conditions.
FCC and IC
This product contains an FCC and Industry Canada certified Bluetooth
®
Low energy wireless transmission
module:
• FCC ID: QOQWT12
• Industry Canada ID: 5123A-BGTWT12A
• Producer: Silicon Laboratories
• Model: WT12 Bluetooth Module
FCC Statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
• This device may not cause interference and
• This device must accept any interference, including interference that may cause undesired operation
of the device.
To Next Page
Loading...
