Note: All reports are printed in the character format using the ASCII set on either A4 or A5 size
paper.
9.1 PRINTING MEASUREMENT RESULTS – PRINT RESULTS
The Print Results position allows you to print the report on the attached printer.
After pressing <ENTER> the instrument checks its current state. If the
measurements are running, printing is not possible, and the appropriate
message is displayed. If no results were recorded the next message is displayed.
If a measurement has been already performed and results are available, the
presented message is displayed.
The data are transferred from the instrument to the attached printer, while the
message is displaying. The instrument returns to the Report list after
transferring all data.
If the Prompt parameter was selected in the Eject Page position, the following
confirmation question is displayed after printing, (path: <Menu> / Report /
Options). You should answer in this case if the paper in the printer has to be
ejected to the new page.
The similar message is displayed after sending out statistics and user filters to
the printer (Print Statistics and Print User Filters).
The message about the time limit is displayed if a printer (or a PC) is not connected or there is any other reason
that it does not receive the data. The instrument waits for the reaction of the user (any key should be pressed
except <Shift> and <Alt>) and after pressing a key it returns to the Report list.
9.2 PRINTING STATISTICS OF SOUND MEASUREMENT RESULTS – PRINT STATISTICS
The Print Statistics position allows you to print results of the statistics analysis
on the attached printer. This position is not accessible for the Vibration
measurements.
To Next Page
Loading...
