ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 198 of 545 2020-04-15
<mode>=2, and <cmdType>=33 (DISPLAY TEXT proactive command), the URC is sent if
allowed by SIM/USIM, the extended format is:
#STN: 33[,<cmdDetails>[,<alphaIdentifier>]]
If bit 7 of <cmdDetails>=1, the response with the #STSR command is required.
<mode>=2, and <cmdType>=34 (GET INKEY proactive command), the URC has the
following extended format:
#STN: 34,<cmdDetails>,<text>
<mode>=2, and <cmdType>=35 (GET INPUT proactive command), the URC has the
following extended format:
#STN: 35,<cmdDetails>,<text>,<responseMin>,<responseMax>[,<defaultText>]
<mode>=2, and <cmdType>=36 (SELECT ITEM proactive command), the URC has the
following extended format:
the first line of output is:
#STN: 36,<cmdDetails>,<numOfItem>[,<titleText>]<CR><LF>
one line follows for every item, repeated <numOfItems> times:
#STN: 36,<itemId>,<itemText>[,<nextActionId>]
<mode>=2, and <cmdType>=37 (SET UP MENU proactive command), the URC has the
following extended format:
the first line of output is:
#STN: 37,<cmdDetails>,<numOfItem>,<titleText><CR><LF>
one line follows for every item, repeated for <numOfItems>:
#STN: 37,<itemId>,<itemText>[,<nextActionId>]
<mode>=2, and <cmdType>=40 (SET UP IDLE MODE TEXT proactive command), the
URC has the following extended format:
#STN: 40[,<idleModeTextString>]
This Additional info section deals with the action initiated by the user (no proactive
commands activated by the SIM/USIM device).
If the call control or SMS control facility present in the SIM/USIM device is activated, when
the user application makes an outgoing call, or sends a SS or USSD, or a SMS, the
following #STN URC could be sent to indicate whether the outgoing call has been
accepted, rejected or modified by the SIM, or if the SMS service center address or
destination has been changed. For parameters meaning refer to Unsolicited fields section.
#STN:
<cmdControlResponse>,<Result>[,<alphaIdentifier>[,<Number>[,<MODestAddr>]]]