Telit Wireless Solutions ML865G1 At Commands Reference Guide

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 225 of 545 2020-04-15
<ds>
integer
0
SMS-STATUS-REPORTs reporting
option
Values:
0
:
status report receiving is not reported to the DTE and is not stored
1
:
the status report is sent to the DTE with the URC described in the
Additional info section.
2
:
if a status report is stored, then the unsolicited result code, described in
Additional info section, is sent.
<bfr>
integer
0
buffered result codes handling method
Values:
0
:
TA buffer of unsolicited result codes defined within this command is flushed
to the TE when <mode>=1..3 is entered (OK response shall be given
before flushing the codes)
1
:
TA buffer of unsolicited result codes defined within this command is cleared
when <mode>=1..3 is entered.
Additional info:
<mt>=1:
+CMTI: <mems>,<index>
<mt>=2:
PDU mode
+CMT: <alpha>,<length><CR><LF><PDU>
TEXT mode
+CMT:<oa>,<alpha>,<scts>[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length>]<CR><LF>
<data>
The parameters written in italics will be present depending on +CSDH last setting.
Class 2 messages and messages in the message waiting indication group (stored message)
result in indication as defined in <mt>=1.
Acknowledge for the received SMS-DELIVER SM is sent to network immediately when +CSMS
<service> is set to '0' or when +CSMS <service> is set to '1', acknowledge is sent via +CNMA
command during predefine time-out, an error is sent to network in case timeout expire, next
+CMT response is depend on acknowledge of current received +CMT response in case
+CSMS <service> parameter set to '1'.
<bm>=2:
PDU mode
+CBM: <length><CR><LF><PDU>

Telit Wireless Solutions ML865G1 Specifications

General

Brand	Telit Wireless Solutions
Model	ML865G1
Category	Wireless modules
Language	English