Thales FMGS - Page 207

FLIGHT PHASES
CRUISE 25
MDA (or MDH) [2R]:
Depending on option selected in OPC file.
DH [3R]:
Displayed if an ILS/MLS or BACK BEAM approach has been inserted in
the ACTIVE F-PLN.
Selecting DH will refer auto call out "MINIMUM" to radio altimeter.
Refer to Operator's policy for DH selection.
If an MDA/MDH is entered any DH previously entered is automatically
cleared.
LDG CONF [4R]/[5R]:
Landing configuration is defaulted to
FULL.
Pressing [4R] prompt will switch the
reference configuration to CONF 3
with associated Vapp & VLS.
Pressing FULL prompt will return to
the previous configuration.
NEXT PHASE [6R]..............Press
PERF GO AROUND page is displayed.
THR RED/ACC [5L] ...................
.............................Check/Modify
ENG OUT ACC [5R] ....................
.............................Check/Modify
Logic is identical to take-off
.
DEST APPR
QNH FLP RETR FINAL
1015 F=148 ILS27R
TEMP SLT RETR MDA
15° S=186 278
MAG WIND CLEAN DH
250°/15 O=210 [ ]
TRANS ALT LDG CONF
6000 CONF3
VAPP VLS
142 137 FULL*
PREV NEXT
<PHASE PHASE>
GO AROUND
FLP RETR
F=148
SLT RETR
S=186
CLEAN
O=210
THR RED/ACC ENG OUT ACC
1580/1580 1580
PREV
<PHASE
DEST APPR
QNH FLP RETR FINAL
1015 F=148 ILS27R
TEMP SLT RETR MDA
15° S=186 278
MAG WIND CLEAN DH
250°/15 O=210 [ ]
TRANS ALT LDG CONF
6000 CONF3*
VAPP VLS
137 132 FULL
PREV NEXT
<PHASE PHASE>
AIRBUS A318/319/320/321
© THALES AVIONICS S.A.
J43126AA 00