Topcon 3D OCT-1 User Manual

172
COMPARING ANALYSIS RESULTS
5.5. Compare ALL
5.5.1. Comparison of the images with different scan modes
On "Both eyes display" and "Comparison", the images of the same scan mode can be compared. When
you use "Compare ALL", you can compare the images of different scan modes.
1 Press the button under the condition that one eye data is displayed. The measurement
data selection screen is displayed.
2 Select the data to be compared on the measurement data selection screen and press the [OK]
button.
Remove a check mark from [Same eye] at the upper left corner. Both eyes data are displayed to
compare both eyes.
Remove a check mark from [Same scan] at the upper left corner. The data of different scan
modes are displayed.
1) The "3D Wide" data is not the object of "Compare ALL".
2) The "3D Macula (V)" data can be compared with only the "3D Macula (V)" data having the
same scan length.
3) In other cases except 2), it is possible to compare the two data whose fixation targets are "Mac-
ula".
4) In other cases except 3), it is possible to compare the two data whose analysis versions (FDA
major versions) are same.

Topcon 3D OCT-1 Specifications

General

Brand	Topcon
Model	3D OCT-1
Category	Medical Equipment
Language	English