22
CAPTURING TOMOGRAMS
2. CAPTURING TOMOGRAMS
If the installed software is the OCT Viewer, this function is not supported.
Capturing images in 3D OCT-2000 software usually requires the following steps:
1 Preparing the patient. (For details, refer to the instruction manual for the instrument body.)
2 Entering patient information. In the case of a new patient, enter the patient information.
3 Pressing the photography button.
4 Select the scan mode in the instrument body.
5 Capturing tomogram and fundus/anterior segment image
(For details, refer to the instruction manual for the instrument body.)
6 Receiving the captured data
7 Automatically saving and analyzing the tomogram and fundus/anterior segment image received
in Step
6.
NOTICE
In case one of the components of the 3D OCT-1 system does not func-
tion properly, an error message may appear when the user attempts to
start a capture session. Please contact Topcon support personnel if this
occurs.
To Next Page
Loading...
