Engine (continued)
2. Install the washer on the bolt and apply red thread locker to the bolt threads.
Install the bolt, torque the bolt to 95 Nm (70 ft-lb).
3. Install the PTO drive belt.
4. Connect the clutch electrical connector to the main wiring harness.
5. Check the clutch air gap; refer to Adjusting the PTO Electric Clutch Air Gap, page
7–4.
6. Install the grill; refer to Removing and Installing the Grill, page 7–14.
4520P Page 4–23 Engine: Engine Service and Repairs
09.40003Rev 00
To Next Page
Loading...
