5-26 Phaser 7750 Printer Service Manual
Image Mis-Registered on Paper
The image area is not centered on the
page or the image is bleeding off of the
page. The printer displays no error code.
1. Run the “Configuration Page” or
“Startup Page” to verify the hard
drive, application, and driver
settings. From the front panel’s
Information Pages Menu, select
Configuration Page or Startup
Page.
2. Is the correct weight paper loaded
in the tray?
3. Ensure that the paper guides are set
to the correct position for the paper
loaded in the tray.
4. Try printing from the other trays. If
the problem only occurs from one
tray, clean the rollers in that tray.
5. Run the Calibrate Margins routine.
From the front panel’s Printer Setup Menu, select Calibration Setup, then
select Calibrate Margins.
6. Verify that Tray 1/MPT or Tray 2 has not been inadvertently set to custom width
while standard sized paper is installed.
7. Verify that the front Tray 1/MPT guide is in the correct position.
3041-54
To Next Page
Loading...
