1-10 Phaser 7750 Printer Service Manual
Mounting Surface Specification
These specifications apply to any Phaser 7750 printer used as a table-top printer,
without a lower tray assembly or cart. There are 4 feet on the bottom of the printer.
The right hand side of the printer is more susceptible to problems due to foot
placement.
1. In order to function properly, the printer must be located on a surface with the
following minimum dimensions. All 4 feet must rest squarely on the mounting
surface.
2. Mounting surface flatness must be within the range shown in the following
figure.
485 mm Min
19.10 in
530 mm Min
20.87 in
7750-339
Right Hand Side
7750-340
5mm Max
To Next Page
Loading...
