Service Parts Disassembly 8-5
Top Cover and Front Panel
1. Remove the right side cover, see page 8-4.
2. Remove 2 screws visible on the right side of the top cover.
3. Open the front cover and remove 1 front screw holding the top cover.
4. Remove the plastic access cover, then remove the image processor board metal
cover and disconnect the front panel cable from the Relay Board P564.
5. Remove the top cover.
Front Panel Removal
1. Open the front door.
2. Release the front panel assembly by inserting a screwdriver or button into the
two access holes indicated in the illustration and push the tabs inward to release.
3. Lift up the panel slightly and unplug the cable connected to the front panel.
4. Release the two tabs on the left-hand end of the front panel assembly and
remove.
S7700-270
Access
Holes
To Next Page
Loading...
