8-56 Phaser 7750 Printer Service Manual
9. Remove the e-clips, washers, and bearings from the LH lift jack assembly roller
guides.
10. Partially remove the left hand side of the main lever assembly.
11. Remove the LH lever hinge.
12. Remove the 4 screws that hold the LH lift jack bracket and remove the bracket.
13. Remove the 4 screws holding the LH lift jack assembly and remove from the
printer.
Note
When reinstalling the LH lift jack assembly install the screws as follows:
upper left, upper right, then the lower screws. Verify that the timing marks
on the main lever and the lift jack assembly align.
To Next Page
Loading...
Need help?
General