YASKAWA DX200 - Page 210

8 System Setup
8.15Numeric Key Customize Function
8-123
182582-1CD
182582-1CD
MH900, DX200 Controller
2. Select “INSTRUCTION”.
– The instruction is shown in the “ALLOCATION CONTENT”.
(1) To change the instruction, move the cursor to the instruction and
press [SELECT]. Then the instruction group list appears.
(2) Select the group which contains the instruction to modify.
(3) When the instruction list dialog box is shown, select the instruction
to be changed.
8.15.2.5 Job Call Allocation
Set this function in the KEY ALLOCATION (EACH) window.
1. Move the cursor to the “FUNCTION” of the key to be allocated and
press [SELECT].
– A selection list appears.
210 of 552