YASKAWA DX200 - 8.15.4 Execution of Allocation

8-132
182582-1CD
182582-1CD
8 System Setup
8.15Numeric Key Customize Function
MH900, DX200 Controller
3. Select “OUTPUT CONTROL INST”.
– The instruction corresponding to the I/O control allocated by key
allocation (SIM) is displayed in the “ALLOCATION CONTENT”.
– The allocated instruction changes automatically when
“ALLOCATION CONTENT” is changed by key allocation (SIM).
Even if the I/O control allocation is changed to the default setting
allocated by the manufacturer with key allocation (SIM), the settings
for key allocation (EACH) remain the same.
8.15.4 Execution of Allocation
8.15.4.1 Executing the Instruction/Output Control Allocation
1. Press the key allocated for instruction allocation or output control
allocation.
– The allocated instruction is displayed in the input buffer line.
2. Press [INSERT] and [ENTER].
– The instruction displayed in the input buffer line is registered.
8.15.4.2 Executing the Job Call Allocation
1. Press the key allocated for the job call allocation.
– The CALL instruction is displayed in the input buffer line.
2. Press [INSERT] then [ENTER].
– The CALL instruction shown in the input buffer line is registered.
8.15.4.3 Executing the Display Allocation
1. Press the key allocated for the display allocation.
– The allocated display appears.
219 of 552