YASKAWA DX200 - 9.2.2 CMOS.BIN Load

9 System Backup
9.2 Backup by CMOS.BIN
9-6
182582-1CD
182582-1CD
MH900, DX200 Controller
6. Select {YES}.
– Select {YES} to save the CMOS data into the CompactFlash.
– When saving the file, if the CMOS.BIN file already exists in the
CompactFlash, the following confirmation dialog box appears.
7. Select {YES}.
– The CMOS.BIN file is overwritten in the CompactFlash.
9.2.2 CMOS.BIN Load
Follow the procedures below to load CMOS.BIN.
1. Turn ON the controller power supply while pressing [MAIN MENU].
2. Change the security mode to the maintenance mode or higher mode.
3. Insert a CompactFlash into the CompactFlash on the programming
pendant.
– When USB memory is used instead of CompactFlash, mount USB
memory and select one among “USB: PENDANT”, “USB1:
CONTROLLER” and “USB2: CONTROLLER” in the {DEVICE}.
4. Select {FD/PC CARD} under the main menu.
– The sub menu appears.
392 of 552