YASKAWA DX200 - 14.12 WAGO Connector

14 Description of Units and Circuit Boards
14.12WAGO Connector
14-47
182582-1CD
182582-1CD
MH900, DX200 Controller
14.12 WAGO Connector
The control power supply unit: CN152 on (JZNC-YPS21-E), and CN303
on the universal I/O circuit board (JANCD-YIO21-E) are equipped with a
connector made by WAGO.
The “wiring tool for the WAGO connector” is necessary to wire the WAGO
connector.
The tools (total 3, 2 types) are supplied with the DX200.
Use them with the appropriate sizes of connectors.
The wiring procedure is described as follows:
1. Insert part A of the wiring tool into one of the holes designed for the
tool.
2. Insert or pull out the wire while pushing the wiring tool downward
(Direction of the arrow).
3. Remove the wiring tool from the connector. (Complete)
Keep this wiring tool for the future use.
Wiring tool for WAGO connector
(DX200 Supplied parts - 2 types)
Hole for the wiring tool
Part A
WAGO connector (e.g. 4 pins type)
Wire
(JANC-YPS21-E) CN152
Control power supply unit:
(JANCD-YIO21-E) CN303
Universal I/O unit:
Connector to be applied
Specification
Stripped lentgh:
7mm
8-9mm
Stripped lentgh:
Max cable outside diameter: 4.1mm dia.
3.4mm dia.
Max cable outside diameter:
Wiring tool for WAGO connector
Push
522 of 552