YASKAWA DX200 - 12 Modification of System Configuration; 12.1 Addition of I;O Modules

12-1
182582-1CD
182582-1CD
12 Modification of System Configuration
12.1Addition of I/O Modules
MH900, DX200 Controller
12 Modification of System Configuration
12.1 Addition of I/O Modules
To add I/O modules, turn OFF the power supply.
1. Turn ON the power supply again while pressing [MAIN MENU]
simultaneously.
2. Change the “SECURITY MODE” to the “MANAGEMENT MODE”.
3. Select {SYSTEM} under the main menu.
– The system window appears.
4. Select {SETUP}.
– The SETUP window appears.
– The items marked with “” cannot be selected.
5. Select {IO MODULE}.
• Addition operation must be performed in the
management mode.
• In the operation mode or editing mode, only reference of
status setting is possible.
429 of 552