YASKAWA DX200 - 11.2 Reset Function

11 Programming Pendant
11.2Reset Function
11-3
182582-1CD
182582-1CD
MH900, DX200 Controller
11.2 Reset Function
Reset function enables to restart only the programming pendant while the
main power supply of the controller is ON.
If unable to operate the robot by the programming pendant causing from
the communications error of the programming pendant, recover the
programming pendant by following procedures.
5. Confirmation of the LED (DS1) display on the JANCD-YIF01- ჱ E
– Check the LED display on the JANCD-YIF01- ჱ E.
6. Reset the programming pendant
– Open the CF slot cover on the programming pendant.
– There is a small hole below the CF insertion slot. Insert a spit to
press inside the hole.
– The programming pendant is rebooted and it starts connecting to
the controller again.
• Check that an alphabet letter or a number is displayed on
the LED display.
• Check that a dot is displayed at the lower right of the LED.
If it is, check that the dot is blinking or lighted.
• If the displayed alphabet or the number is continuously
changing, write down them in order.
426 of 552