YASKAWA DX200 - 8.6.4 Clearing the Interference Area Data

8 System Setup
8.6 Interference Area
8-77
182582-1CD
182582-1CD
MH900, DX200 Controller
8.6.4 Clearing the Interference Area Data
1. Select {ROBOT} under the main menu.
2. Select {INTERFERENCE}.
– The INTERFERENCE AREA window is shown.
3. Select interference signal to be cleared.
– Select the desired interference signal number to be cleared using
the [PAGE] or by number input.
– When selecting the desired interference signal number by number
input, select [PAGE] to input the desired signal number.
4. Select {DATA} in the pull-down menu.
164 of 552