10-2
182582-1CD
182582-1CD
10 Upgrade Function
10.2Upgrade Procedure
MH900, DX200 Controller
10.2.2 Automatic Upgrade of YPP
In case that the pendant application version of YPP is older than the one
of YCP21 or the pendant application version of YPP is not compatible to
the one of YCP21, the YPP is automatically upgraded.
Not only the application software but the OS of the Programming Pendant
is also upgraded automatically.
(OS: Operating System)
1. After the automatic upgrade process is completed, the communication
process between YCP21 and YPP is restarted.
– Some upgraded software require restart.
In this case restart is done automatically and the communication
process between YPP and YCP21 starts again.
2. Initial window appears approx. 45 seconds later.
• Every time the OS is upgraded automatically, restart is
done. There is no need of calibrating because the
calibration data is taken over.
• To start the controller without the auto upgrade process,
press all of the [Interlock]+[5]+[Select] keys at the same
time to start.
To Next Page
Loading...
