YASKAWA DX200 - 14.6.14 Connection for Direct-in

14 Description of Units and Circuit Boards
14.6Machine Safety Terminal Block Circuit Board (JANCD-YFC22-E)
14-35
182582-1CD
182582-1CD
MH900, DX200 Controller
14.6.14 Connection for Direct-in
 Direct-in (Servo) 1 to 6
This signal is used to input a responsive signal in search functions.
Fig. 14-26: Connection for Direct-in (Servo) 1 to 6
86
87
88
89
90
91
85
81,82
83,84
CN219
024V2
+24V2
AXDIN1
AXDIN2
AXDIN3
AXDIN4
AXDIN5
AXDIN6
AXDIN_COM
86
87
88
89
90
91
85
81,82
83,84
CN219
024V2
+24V2
AXDIN1
AXDIN2
AXDIN3
AXDIN4
AXDIN5
AXDIN6
AXDIN_COM
Direct-in (Servo) 1
Direct-in (Servo) 2
Direct-in (Servo) 3
Direct-in (Servo) 4
Direct-in (Servo) 5
Direct-in (Servo) 6
Major Axes Control
Circuit Board
(SRDA-EAXA21A)
Connect the jumper cable.
Connect the jumper cable.
The part of wiring is that if there is a slave for the coordinated control side
major axes control circuit board (SRDA-EAXA21A).
Major Axes Control
Circuit Board
(SRDA-EAXA21A)
Machine safety terminal
block circuit board
(JANCD-YFC22-E)
Machine safety terminal
block circuit board
(JANCD-YFC22-E)
510 of 552