14-34
182582-1CD
182582-1CD
14 Description of Units and Circuit Boards
14.6Machine Safety Terminal Block Circuit Board (JANCD-YFC22-E)
MH900, DX200 Controller
• Rated output value is DC24V and less than 50mA.
Avoid excessive load when connect.
• When connect the inductive load, such as the safety
relay, with the output circuit, use of the built-in protective
circuit for the surge suppressor or connect the flyback
diode in parallel to the inductive load to suppress the
surge voltage.
It may cause the damage on the output circuit.
• The feedback signal must be inputted to the DX200
when use the universal safety output signal.
To Next Page
Loading...
