YASKAWA DX200 - 8.23.3 Performing the Safety Logic Circuit; 8.23.4 The Safety Logic Circuit Expansion Function

8-226
182582-1CD
182582-1CD
8 System Setup
8.23Safety Logic Circuit
MH900, DX200 Controller
8.23.3 Performing the Safety Logic Circuit
The safety logic circuit is always performed except updating the file.
Confirm that the status is “DONE”. When setting signal is turned ON, the
mark “ ” is displayed, and when setting signal is turned OFF, the mark
“ ഊ ” is displayed.
8.23.4 The Safety Logic Circuit Expansion Function
8.23.4.1 Setting for the Safety Logic Circuit Expansion Function
When using the safety logic circuit expansion function, start the
maintenance mode and perform the following settings.
1. Start the maintenance mode.
– While pressing the main menu key on the programming pendant,
turn ON the controller. The maintenance window is displayed.
313 of 552