YASKAWA DX200 - Page 312

8 System Setup
8.23Safety Logic Circuit
8-225
182582-1CD
182582-1CD
MH900, DX200 Controller
(2) Without feedback signal connection
69
70
CN219
DX200
GSOUT1_1-
GSOUT1_1+
71
72GSOUT1_2-
GSOUT1_2+
77
78GSEDM1-
GSEDM1+
(JANCD-YFC22-E)(JANCD-YSF22-E)
Machine Safety I/O
Logic Circuit Board
Machine Safety Terminal
Block Circuit Board
Universal Safety Output 2
Universal Safety Output 1
Dual Sianals
When feedback signal is not intaken, errors (wire sticking, etc.)
of the devices driven by the universal safety output signal(GSOUT)
(safety relay, contactor, etc.) is not detected.
Perform the error detection (signal mismatch) with the receiving side
devices (safety PLC, etc.).
69
70
CN219
DX200
GSOUT1_1-
GSOUT1_1+
71
72GSOUT1_2-
GSOUT1_2+
77
78GSEDM1-
GSEDM1+
(JANCD-YFC22-E)(JANCD-YSF22-E)
Machine Safety I/O
Logic Circuit Board
Machine Safety Terminal
Block Circuit Board
Lamp
Universal output 1
It is possible to use either one of the dual safety output signals
and use it as a universal output signal. (cf. drive of lamp)
The 1ch and 2ch are controlled simultaneously, so they
cannot be used as different signals.
312 of 552