4 Connection
4.3 Connection Methods
4-15
182582-1CD
182582-1CD
MH900, DX200 Controller
4.3.5 Connecting the Programming Pendant
1. Connect the programming pendant cable to the connector on the door
lower right side of the controller cabinet.
Fig. 4-16: Connecting the Programming Pendant
– The manipulator, controller, and the programming pendant
connections are now complete.
WARNING
• Always close the door of the controller except for maintenance.
• Make sure to rotate all the door locks counterclockwise.
If dust or water enter inside the controller, electric shock or breakdown
of the controller may result.
Alignment mark
To Next Page
Loading...
