8 System Setup
8.4 ARM Control
8-43
182582-1CD
182582-1CD
MH900, DX200 Controller
8.4.3 Tool Load Information Setting
8.4.3.1 Tool Load Information
Tool load information includes weight, a center of gravity position, and
moment of inertia at the center of gravity of the tool installed at the flange.
These are registered in the tool file.
• Set the tool load information correctly.
The speed reducer longevity might decrease or the alarm might occur
when the tool load information is not set correctly.
To set the tool load information correctly, following message appears
when inputting the information.
“Input correct tool information. Using robot with wrong tool information
may result in premature failure of the robot.”
• Confirm the operation path of robot of each job which uses the tool
file after the tool load information is changed.
Set the tool load information before teaching the job after the tool is
installed.
Confirm the operation path of each job which uses the tool file when the
tool load information should be modified after teaching.
Modifying the tool load information may slightly change the operation
path. To avoid injury or damage to machinery caused by collision
between tool and positioner, make sure to check the operation path
before executing a job.
* Flange Coodinates
XF: It is a direction right above when T axis
is 0 pulse position and the flange surface
of the manipulator turned to the front.
YF: Y axis led by XF,ZF
ZF: Perpendicular direction from flange surface
XF
ZF
YF
XF'
ZF'
YF'
Center of Gravity Position
(
Xg, Yg, Zg
)
Iy
Iz
Ix
Moment of inertia around the Center of Gravity
Ix, Iy, Iz
Weight:W
To Next Page
Loading...
