YASKAWA DX200 - Page 296

8 System Setup
8.23Safety Logic Circuit
8-209
182582-1CD
182582-1CD
MH900, DX200 Controller
8.23.2.4 Timer Delay
Set up the delay time of the output signal to use by the safety logic circuit.
In the TIMER DELAY, there are “ON DELAY TIME” to delay the ON output
and “OFF DELAY TIME” to delay the OFF output . It can be four timer
settings.
When setting the 500msec to ON DELAY TIME,
When setting the 300msec to OFF DELAY TIME,
The initial value is 100(25 ᅜ 2)[msec]. It is able to set every 4msec up to
399,996 (99,999 ᅜ 25)[msec].
1. Displaying the window.
• If press “YES” on the confirmation dialog, the all window
information, such as {M-SAFETY SIGNAL ALLOC},
{SAFETY SIG. BOARD ALLOC}, {TIMER DELAY SET},
and {SAFETY LOGIC CIRCUIT} are updated. The
written file in the FLASH ROM of the machine safety
circuit board is also updated.
• When performing {WRITE}, the universal safety and the
safety field bus output signals, which are sent from the
machine safety circuit board, are turned OFF till the
writing processing is finished.
500msec
ON DELAY time
Output
Safety logic output
OFF DELAY time
Output
Safety logic output
300msec
296 of 552