YASKAWA DX200 - Page 304

8 System Setup
8.23Safety Logic Circuit
8-217
182582-1CD
182582-1CD
MH900, DX200 Controller
7. Transferring or updating the file
– After editing, select {WRITE} button.
If there is a blank line in the safety logic board, it will be filled
automatically.
The file is transferred to the machine safety circuit board
(type:YSF21-E). When the file transfer is done correctly, the
confirmation dialog “Update the file?” appears.
– Press “YES”, and then the file is updated.
The file transferred to the machine safety circuit board
(type:YSF21-E) is written in the FLASH ROM.
The status becomes “DONE” from “NOT DONE”.
If press “NO”, the file will not be updated. The status remains “NOT
DONE”.
304 of 552