YASKAWA DX200 - Page 339

8-252
182582-1CD
182582-1CD
8 System Setup
8.23Safety Logic Circuit
MH900, DX200 Controller
When #1 GSIN1 signal is ON, #1 GSOUT1 is ON for one second.
5. To enable the changed settings, press “WRITE” and then “CONFIRM”.
When the data is updated correctly, the status in the title line is
changed from “NOT DONE” to “DONE”.
When using the DSU or DSD instruction, be sure to set
TMR to TIMER for the output signal. If “WRITE” is pressed
without setting TMR to TIMER for the output signal,
“ERROR 4241: Safety logic circuit is not set” is displayed on
the programming pendant as shown in the following
window.

*6,1
*6287
VHF
339 of 552